|
Ingot Molds are an essential item in all shop foundries for
handling and storing melted metal. Scrap metal can be fluxed,
cleaned and poured into ingots, then stored for future
requirements. The No. 12 size is used for pigging ingots
because of the large capacity. The No. 6 is used for draining
crucible after the final heat.
No. 6 INGOT MOLD # 030750
Metal mold used to form ingots from extra molten metal
remaining in crucible. Ingot size 6" long, 3-1/2" wide, 1-1/2"
thick. Overall dimensions: 9" x 12". Approximate weight is 11
lbs.
No. 12 INGOT MOLD # 030760
Metal mold used for pigging cleaned scrap and remelt metal
into ingots for storage. Ingot size 10-3/4" long, 3-1/2" wide,
1-1/2" thick. Ideal size for stacking, for storage and
melting. Overall dimensions: 11" x 14". Approximate weight is
20 lbs.
Pick-Up Tongs
Special tongs required for handling hot castings or for
charging additional metal to the crucible during melt-down.
The 24 inch is normally used for shake-out, and the 42 inch
for charging. (Not guaranteed for picking up casting over 25
lbs.) MAXIMUM OPENING 3 1/2 INCHES
|
Part Number |
Tong Number |
Overall Length |
Approx. Wt. |
|
031621 |
58-24 |
24" |
3 lbs. |
|
031623 |
58-42 |
42" |
5 lbs. |
|
